How to Install a Rubber Flat Roof DIY on a Garage, Shed, Porch, carport, or Commercial Roof.
Turbo Poly Seal https://bergstromm.com/'>https://bergstromm.com/'>https://bergstromm.com/'>https://bergstromm.com/
Two people with very few tools can install this. We demonstrate how to install a PeelAndStick rubber roof with many tips and tricks to avoid leaks later on. This method is for anyone with a slightly slanted flat roof who needs to replace it. If installed correctly, this rubber roof will last 20 30 years.
Watch this video On how to Repair leaks on an EPDM Rubber Roof    • Why EPDM Rubber Roofs Leak and How to...  
Turbo Poly Seal at https://bergstromm.com/'>https://bergstromm.com/'>https://bergstromm.com/'>https://bergstromm.com/
Applications where Super Silicone Seal is used:    • Use this Flat Roof Coating to Repair/...  
Application where Turbo Poly Seal is used:    • Anyone can Repair a Metal Roof Seam l...  
Videos on Repairing Metal Roof leaks:    • Metal Roof Coating gone bad. Do not g...  
Repairing Chimney leaks:    • Travelled from Pennsylvania to Skagwa...  
Skylight Leak Repairs:    • Skylight leaking due to lack of curb ...  
Channel: https://www.youtube.com/ @FlatRoofDoctor
#flatroofrepairs #roofrepair #chimneyrepair

Shopping list for Flat Roof Installation DIY, Garage, Shed
Peel and Stick Rubber membrane Cap Sheep (any brand)
Peel and Stick Base Sheet
Karnak 81 or 66 Adhesive Trowel Grade
1 gal of Turbo Poly Seal by Bergstromm.com
1 Roll of Polyester fabric
Lacquer Thinners where necessary

Tools Required for Flat Roof Installation DIY, Garage, Shed
Disposable brush
Utility knife with straight and hook blades
Small Propane Torch
Bullnose Towel
Scissors
Stirring stick
Garbage bag
Dolly
Rags for cleaning

1. Materials: Any roof brand peelandstick cap sheet and peelandstick base, roofing nails, and Karnak 81 or 66 trowelgrade adhesive.
2. Preparation: Sweep or blow the surface clean of dust and debris. Make sure it is dry.
3. Installation: Install over any surface. Starting from the bottom, install new metal edging, install the base over the entire surface, and then install the cap sheet starting from the bottom. Use Karnak to seal edges and end laps if the roof pitch is too low.
4. Tools: Utility knife with regular blade and hook blade, Hammer, Optional small propane torch

Turbo Poly Seal https://bergstromm.com/'>https://bergstromm.com/'>https://bergstromm.com/'>https://bergstromm.com/
FTC Affiliate Disclaimer I get commissions for purchases made through links in this post.

Chapters:
0:00 Quick, Cheap, Easy Roof
0:25 Roof Requirements
2:38 Installing the base
5:59 Installing the Cap Sheet
8:32 Welding membrane to the wall
10:59 Installing membrane around vents
17:00 Securing roof for the night
22:33 Flashing in vents and vent pipes

‪@FlatRoofDoctor‬ ‪@AllRoof.‬